Tuesday, November 30, 2021

No New Permits; Two Sinclair DUCs Reported As Completed -- November 30, 2021

Active rigs:

$66.68
11/30/202111/30/202011/30/201911/30/201811/30/2017
Active Rigs3114576654

No new permits
.

One permit renewed:
  • 33206, NP Resources, Mosser Federal 143-102-22-15-4H, Billings County
Two producing wells (DUCs) reported as completed:
  • 36791, 968, Sinclair, Harris Federal 4-32H, Lone Butte, lot 2 section 5-146-97; no other data,
    • in this section there are two Sinclair pads
    • one pad runs west to east, eight wells
    • the other pad runs roughly north to south, with three wells
  • 36792, 1,629,Sinclair, Harris Federal 3-2H, Lone Butte, no other data,

Sinclair wells sited in section 5-146-97:

  • 33426, 33-025-0277, conf, Sinclair, Crosby Creek 7-5TFH, Little Knife,
  • 33425, 33-025-0276, loc, Sinclair, Crosby Creek 6-5H, Little Knife,
  • 36790, 33-025-03883, loc, Sinclair, Harris Federal 30-32H, Lone Butte,
  • 36791, 33-025-03884, 968, Sinclair, Harris Federal 4-32H, Lone Butte,
  • 36792, 33-025-03885, 1,629, Sinclair, Harris Federal 3-32H, Lone Butte,
  • 33424, 33-025-03275, drl/NC, Sinclair, Crosby Creek 5-5H, Little Knife,
  • 36793, 33-025-03886, drl/NC, Sinclair, Crosby Creek 2-32H, Little Knife,
  • 32461, 33-025-03102, drl/NC, Sinclair, Crosby Creek 4-5H, Little Knife,


  • 19304, 174, SInclair, Crosby Creek 1-5H, Little Knife, t11/11; cum 180K 8/21; off line 9/21; 
  • 23459, 1,358, Sinclair, Crosby Creek 2-5H, Little Knife, t12/12; cum 138K 7/21; F; off line 8/21; remains off line 9/21; 
  • 25303, 103, Sinclair, Crosby Creek 3-5H, Little Knife, t9/13; cum 238K 8/21; F; was off line for mjuch of 9/21;

The definitive active rig report:

  • the NDIC reports 32 active rigs and, yes, there are 32 rigs and 32 sites listed;
  • however, CLR's H&P 492 is counted twice, once on LCU Ralph 4-27H (#37013) and also once on LCU Ralph 3-27H1, so, in fact, assuming no other errors, only 31 active rigs;
  • Kraken is not on the list

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.