The NDIC hearing dockets are tracked here.
The usual disclaimer applies. As usual this is done very quickly and using shorthand for my benefit. There will be factual and typographical errors on this page. Do not quote me on any of this. It's for my personal use to help me better understand the Bakken. Do not read it. If you do happen to read it, do not make any investment, financial, job, relationship, or travel plans based on anything you read here or think you may have read here. If this stuff is important to you, and I doubt that it is, but if it is, go to the source.
Thursday, September 29, 2022
Supplement
Cases, not permits:
29629, NDIC, XTO, termination of the Grinnell-Bakken Unit, McKenzie, Williams;
Thursday, September 29, 2022
Fourteen pages
Cases, not permits:
- 29599, NDIC, XTO, termination of the Hofflund-Bakken Unit, McKenzie, Williams
- 29600, NDIC, Liberty Resources Management Co., LCC, review the pilot injection project; Haley 158-93-29-32-10MBH; sections 29/30/31/32-158-93; East Tioga-Bakken; Mountrail.
- 29601, NDIC, EOG Resources, review the pilot injection project; Burke 18-27H, SW/4 SE/4 of section 27-155-90, Mountrail
- 29602, Crescent Point Energy, Little Muddy and/or Winner-Bakken, establish eleven overlapping 2560-acre spacing units; approximately six wells; Williams County.
- 29603, CLR, Little Knife-Bakken, establish a 2560-acre unit, sections 14/15/22/23-146-97; one well; Dunn County;
- 29604, SHD Oil & Gas, LLC, Van Hook and/or Deep Water Creek Bay-Bakken, establish a 4160-acre unit, sections 15/16/17/18/19 and the N/2 of section 21-150-91; eight wells; McLean, Dunn counties. See graphic at this post.
- 29605, Slawson, Big Bend-Bakken, establish an overlappnig 2560-acre unit, sections 34/35-153-91 and sections 2/3-151-92; two wells; Mountrail County;
- 29606, Slawson, Bully-Bakken, twenty wells; see this post. McKenzie County;
- 29607, Hunt, Bailey, Wolf Bay and/or Werner-Bakken, i) establish an overlapping 1920-acre unit, section 36-147-93 and sections 1/12-146-93; one well; ii) establish an overlapping 2560-acre unit, section s2/3/10/11-146-93; one well; iii) establish two overlapping 3840-acre units, sections 1/2/13- 146-93 and sectinos 6/7/18-146-92 and sectinos 24/25/26-146-93 and section s19/30/31-146-92, and one well between the two units; three wells; Dunn County;
- 29608, NDIC, Hardscrabble or Indian Hill-Bakken, consider altering spacing units in sections 1/12/13/24/25/36-153-102; Williams, McKenzie; affects Grayson Mill, RIM Operating, Oasis.
- 29609, Yellowstone River Beer, on Grayson Mill Operating,
- 29610, CLR, Little Knife-Bakken, nineteen wells, see this post.
- on an existing 1280-acre unit, sections 13/24-146-97, nine wells, Dunn County.
- on an existing 1280-acre unit, sections 14/23-146-97, ten wells, Dunn County.
- 29611, CLR, pooling,
- 29612, CLR, pooling,
- 29613, CLR, pooling,
- 29614, CLR, pooling,
- 29615, Slawson, pooling,
- 29616, Slawson, pooling,
- 29617, Slawson, pooling,
- 29618, Slawson, pooling,
- 29619, Slawson, pooling,
- 29620, Slawson, pooling,
- 29621, Slawson, pooling,
- 29622, Slawson, pooling,
- 29623, Slawson, pooling,
- 29624, XTO, flaring,
- 29625, XTO, commingling,
- 29626, XTO, commingling,
- 29627, EOG, commingling,
- 29628, Crescent Point Energy, SWD,
- 29629,
Wednesday, September 28, 2022
Twelve pages
Cases, not permits:
- 29558, NDIC, confiscation, Clean Petroleum Services, treating plant, SWSE section 25-150-100; McKenzie County
- 29559, NDIC, Grinnell-Bakken; review status of the leases in sections 30/31 within the 2560-acre unit described as sections 29/30/31/32-154-96, and the progress towards developing said sections 30/31 as a standup 1280-acre unit; McKenzie, Williams;
- 29560, Oasis, Bull Butte and/or Bonetrail-Bakken, establish an overlapping 3840-acre unit, sectiinos 3/4/9/10/15/16-156-102; one well; Williams County;
- 29561, Oasis, Bull Butte-Bakken, establish an overlapping standup 1920-acre unit, sections 4/9/16-156-102, four wells; Williams County;
- 29562, Oasis, Bull Butte-Bakken, one well
- 29563, Oasis, Bull Butte-Bakken, one well,
- 29564, Oasis, Bull Butte-Bakken, four wells:
- 29565, Mercury Resources, LLC, Rocky Hill-Madison, ten wells:
- 29566, Cornerstone Natural Resources LLC, Northeast Foothills-Bakken, three wells;
- 29567, MRO, Killdeer-Bakken;
- 29568, Hess, Tioga and/or White Earth-Bakken,
- 29569, Hess, Tioga-Bakken
- 29570, Hess, Big Butte and/or Alger-Bakken;
- 29571, Hess, Big Butte and/or Alger-Bakken,
- 29572, Cornerstone Natural Resources LLC, pooling,
- 29573, Cornerstone Natural Resources LLC, pooling,
- 29574, Cornerstone Natural Resources LLC, pooling,
- 29575, Hess, Tioga-Bakken, nine wells;
- 29576, Hess, Ross-Bakken six wells;
- 29577, Hess, pooling,
- 29578, Hess, pooling,
- 29579, Hess, pooling,
- 29580, Hess, commingling,
- 29581, Hess, commingling,
- 29582, Hess, commingling,
- 29583, Oasis, pooling,
- 29584, Oasis, pooling,
- 29585, Oasis, pooling,
- 29586, Oasis, pooling,
- 29587, Oasis, pooling,
- 29588, Grayson Mill, commingling,
- 29589, Whiting, commingling,
- 29590, Whiting, commingling,
- 29591, Ovintiv, commingling,
- 29592, MRO, Killdeer-Bakken, eight wells;
- 29593, MRO, pooling,
- 29594, MRO, pooling,
- 29595, MRO, pooling,
- 29596, MRO, commingling,
- 29597, MRO, commingling,
- 29598, MRO, commingling,
What is difference between "pooling" and "commingling" I think I know but would rather have you go out on that limb. Smile face
ReplyDeleteTwo completely different, unrelated "things."
DeletePooling: an administrative, regulatory action to get all the actions completed with regard to mineral holders to have the well that will soon be drilled (or is being drilled) sorted out with regard to royalties to be paid.
Commingling: where the operator combines all the liquids or vapors from more than one well into one delivery point. Without commingling, the product from each well needs to be kept separate from the product from all other wells. If commingling is allowed, once the product is brought to the surface and analyzed, it can be commingled with product from other wells.
Interesting.... seeking to return a 2,560 spacing back into two 1,280's. Wonder why... 29567, MRO, Killdeer-Bakken;
ReplyDeleteYes, I saw that, also. I'll come back to it. Will ask if any readers might have a possible explanation.
DeleteIt now makes sense: see this post:
Deletehttps://themilliondollarway.blogspot.com/2022/09/mro-converts-planned-overlapping-2560.html.
Thanks. I was only totally wrong.
ReplyDeleteI sometimes forget things I shouldn't and I certainly can't explain them well, but hopefully, you got a pretty good idea.
Delete