Take a look at BR's #17118 just shows the potential of the untapped barrels by refracking old wells. It has produced more bbls in 9 months since the refrack than it did in the initial 6 years of production.Now, to search the blog to see if I've talked about this well before:
- 17118, 289, BR, Remington 14-11H, Blue Buttes, t6/08; cum 211K 8/16; only 14 days in 8/16
Early production:
BAKKEN | 12-2008 | 31 | 1972 | 1804 | 494 | 2333 | 1293 | 1040 |
BAKKEN | 11-2008 | 30 | 2197 | 2209 | 232 | 2681 | 1613 | 1068 |
BAKKEN | 10-2008 | 31 | 2953 | 3067 | 231 | 3774 | 1930 | 1844 |
BAKKEN | 9-2008 | 25 | 3157 | 2990 | 1110 | 3264 | 362 | 2902 |
BAKKEN | 8-2008 | 4 | 0 | 213 | 147 | 64 | 31 | 33 |
BAKKEN | 7-2008 | 31 | 4432 | 4212 | 1436 | 3607 | 3607 | 0 |
BAKKEN | 6-2008 | 30 | 1260 | 968 | 702 | 596 | 596 | 0 |
Production after December, 2008, until June, 2014, was "pathetic." Then it was taken off-line for the entire month of July, 2014, and came back on line in September, 2014. Here is the production profile from August, 2014, to the present:
Pool | Date | Days | BBLS Oil | Runs | BBLS Water | MCF Prod | MCF Sold | Vent/Flare |
---|---|---|---|---|---|---|---|---|
BAKKEN | 5-2015 | 31 | 7983 | 7632 | 1980 | 10307 | 10230 | 0 |
BAKKEN | 4-2015 | 28 | 7805 | 7853 | 1567 | 8483 | 8413 | 0 |
BAKKEN | 3-2015 | 5 | 2374 | 2543 | 487 | 2322 | 2310 | 0 |
BAKKEN | 2-2015 | 28 | 9012 | 8947 | 2497 | 17242 | 17172 | 0 |
BAKKEN | 1-2015 | 31 | 12119 | 12140 | 2931 | 17289 | 17212 | 0 |
BAKKEN | 12-2014 | 22 | 8393 | 8058 | 1774 | 8847 | 8614 | 179 |
BAKKEN | 11-2014 | 24 | 13919 | 13866 | 2541 | 16851 | 16791 | 0 |
BAKKEN | 10-2014 | 23 | 19032 | 19016 | 4009 | 16529 | 16472 | 0 |
BAKKEN | 9-2014 | 7 | 8735 | 8690 | 5196 | 12793 | 0 | 12775 |
BAKKEN | 8-2014 | 1 | 11 | 12 | 0 | 0 | 0 | 0 |
So, what gives? What's the file report have to say?
From the most recent sundry form, recieved by the NDIC on April 24, 2014:
BR requests: to restimulate (re-frack) the lateral and increase production. The well was drilled and completed as an open hole well with a single stage completion. Precision 825 will be used to install a 4 1/2" liner and and the well restimulated (re-fracked).I assume "Precision 825" is a drilling rig.
BR does not currently use any of the following in fracking:
- fuels, diesel
- fuels, diesel, no. 2
- fuel oil no. 2
- fuel oil no. 4
- kerosene
If this was back-payments for production sold from the two wells, your interest may not be great enough to exceed the requirement in the paragraph aboeve (greater than $50). Oil prices in May 2007 were around $60/barrel and rose to over $140/barrel in July 2008. Unfortunately, prices dropped drastically to a low of around $20/barrel in December 2008 and this is reducing your payments significantly from what they were last year.Original drilling / geologist's summary:
- target: "Sanish" member of the Bakken formation
- 20,831 feet
- gas units in the 5-- to 1,000 unit range; 5 - 8' flare
- open-hole frack; perforated intervals, 11,193 to 20,382 feet
- 1,044,000 lbs sand
- 8,699 bbl gelled cross-linked fluid
- IP: 289
The original application said the target zone was the "Bakken," not otherwise specified.
In a long note like this, there will be factual and typographical errors. If this information is important to you go to the source.
Look at the graphic: of the nine wells, one was recently re-fracked, greatly increasing production; the other 8 are waiting to be completed. And this is just one section in the entire Bakken.
There's one more data point about this well that is of interest, but I am purposely not posting it. I am posting this teaser in case someone else points it out, and I can say that I noted it also (for bragging purposes).
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.